Clear Acrylic Lens Holder + Hardware Kit for HalloWing
Customers who bought this product also bought:
- Block battery with JST connector and ON-OFF inter and clip 3xAA belt
- Pink and Purple Braided USB A to Micro B Cable - 2 meter long
- NeoPixel Ring with 16 LED RGB LED and driver integrated
- Circuit Playground Express Adafruit
- Block battery with JST connector and ON-OFF inter 3xAAA
- Round Black Zipper Case
- Convex Glass Lens with Edge - 40mm Diameter
- Mono 2.5W Class D Audio Amplifiers - PAM8302
- Conductive fiber - 20 um 10g stainless steel
This is the perfect kit for mounting a convex lens (glass or plastic) on your HalloWing! This holder has been laser cut specifically for lenses with an edge, so we cannot guarantee that it will fit any old convex lens. But it works very well with ours. And of course, the mounting hardware is included so you can snap it directly onto your HalloWing. The assembly takes less than five minutes, just use a screwdriver.
Please note: It will not work with other display cards, just with Hallowing.
HalloWing Laser-cut lens holder
8 x M2.5 5 mm screws
4 x M2.5 6mm F-F hexagonal distance
Does not include HalloWing or convex lenses!
Lens holder dimensions: 52.3 x 50 x 50 x 2.8 mm
Plastic case for Raspberry PI B + or FT2 with smoke base and transparent cover.9,54 € Add to cart
A simple and effective case for your Arduino UNO card.5,94 € Add to cart
A small case with transparent lid for your projects.11,94 € Add to cart
A large case with transparent lid for your projects.23,94 € Add to cart
A skull-shaped development card for Halloween!41,94 € Add to cart