Customers who bought this product also bought:
- 20 Male - female 150mm Premium dupont wires Kit
- 10 X resistors 0.25W 1kohms
- Clear White 3mm LED (25 pack)
- Switch double SPDT
- 10 X resistors 0.25W 10kohms
- 40 Male - Male 150mm Premium dupont wires Kit
- 10 X Diodes 1N4148
- Controleur de dalle tactile resistive - STMPE610
- Tapis de travail en silicone isolé - 34cm x 23cm x 4 mm
Sliding scale pricing
|Adafruit I2S Stereo Decoder - UDA1334A Breakout||10||7,92 €|
This UDA1334A I2S stereo DAC is perfectly adapted to any I2S audio interface with I2S output. It's affordable but it sounds good! The NXP UDA1334A is ideal: you can use logical levels from 3.3V to 5V (a rarity) and process several different formats by setting two pins to a high or low level. The DAC immediately processes the data and provides you with a clear, analog stereo output at the line level. It's even cool with I2S interfaces without MCLK like the Raspberry Pi (ideal for) - a built-in PLL will generate the correct clock from the bitclock signal.
For inputs, you can use the classic I2S (default) or 16-bit, 20-bit or 24-bit left-justified data. You can set it to provide a master clock-input system, but we set it to generate it for you by default, so you only need to connect the Data In, Word Select (left/right clock) and Bit Clock lines. If you wish, there is a MUTE mode and a de-emphasis filter that you can activate.
We have put a lot of ferrite beads, a low-loss regulator, and the recommended band-pass filter so that you get a very good performance. With a sinusoidal wave generator, we scanned 20-20KHz and saw no attenuation or distortion. Plug in the 3.5 mm stereo headphone jack or the pads compatible withbreadboard. We think you'll like this DAC!
Each control comes with a stereo I2S stereo DAC breakout and a solderable connector.
Product Dimensions: 40.0 mm x 25.0 mm x 7.1 mm / 1.6 in. x 1.0 in. x 0.3 in.
Product weight: 4.6g / 0.2oz
A small MAX98306 base amp to give power to your audio editing.10,74 € Add to cart
An amplifier I2S 3W class D MAX98357A for Raspberry PI or Genuino Zero based.7,14 € Add to cart
A cap card to add a stereo I2S audio amp to your RAspberry PI.15,54 € Add to cart
A breakout with microphone in IS MEMS card.8,34 € Add to cart
A small amplifier based on PAM8302 to give your audio editing power.4,74 € Add to cart
A 2.1W Class D stereo audio amplifier based on TPA2012.11,94 € Add to cart