JST PH 4-Pin to Femelle Header Cable - I2C STEMMA Cable - 200mm
A 200mm JST PH 4-pin cable to 4 male femelle.
Customers who bought this product also bought:
- Mini spy Camera with trigger for photo and video
- Arduino Uno - DIP Rev3
- Breadboard - 400 contacts
- Lot of 12 cables with crocodile 381mm clips
- Cable JST Femelle 2 pins 100mm
- Box camera Raspberry PI with mounting Tripod 1.4 "
- Pack of male and female Dupont crimp connectors
- Pack of 25 LED 3mm Red
- Box for Arduino Yun
This cable will allow you to transform a 4-pin JST PH cable port into 4 individual wires with high-quality 0.1" female connectors at the end. We have them to match any of our cards with STEMMA connectors such as Hallowing or Trellis M4. Can also be used with any STEMMA breakout! This one has female pins, so it can be used to connect to a male connector or on rigid cables.
The wires are even color-coded:
Black for GND
Red for VCC
White for SDA
Green for SCL
Even if it is a JST PH connector, it fits into a Seeed Grove connector and also has the appropriate wires.
Cable length: 7.8" / 200mm
Wire diameter: 1.6mm
JST connector: 8.5mm
JST pitch: 2mm
An extension cable JST - PH 2 pine trees to the steps of 2mm with a length of 500mm.2,34 € Add to cart
Kit 20 wires length 300mm with ends male and male premium.4,74 € Add to cart
A power cable JST - PH2 with a switch.3,54 € Add to cart
A set of 2 connectors 4 points JST SM 2.5mm male and female pre-wired.1,80 € Add to cart
A 200mm cable to adapt a 3 pin JST PH connector to male pins.1,50 € Add to cart
A 2 point pico blade pre-wired 200mm pico blade connector.1,14 € Add to cart
A 150mm long STEMMA cable with 4-pin female JST-PH connectors0,90 € Add to cart