Customers who bought this product also bought:
- Edge-Launch SMA connector for 1.6mm 0.062" circuit
- Gaines thermoretractables black Pack
- Flora RGB Smart NeoPixel version 2 - Sheet of 20
- Lot of 12 cables with crocodile 381mm clips
- 5 compartment storage box
- Screen TFT 1.44 "with MicroSD - ST7735R
- Spool of thread thin 2 strands stainless - 23 m
- Driver woven fabrics - money - 20cm square
- Micro-Switch hand switch three contacts
Want to add BLE Bluetooth connectivity for your Flora project? With the BLE used by all recent smartphones and tablets, it's very easy to add a wireless connection with this Flora Wearable Bluefruit LE Module!
The Flora Wearable Bluefruit LE Module allows you to add a BLE bluetoth link simply for your Flora project.
This multi-function module has the Nordic TX/RX connection standard. In this mode, the Bluefruit module acts as a data stream that transmits data simply with an IOS or Android application.
- ARM Cortex M0 core 16MHz Core ARM
- 256KB flash memory
- 32KB SRAM
- Transport: UART @ 9600 baud with HW flow control (CTS + RTS required)
- 5V compatible inputs (Arduino Uno, etc.)
- Integrated voltage regulator 3.3V
- Bootloader with support for OTA firmware update security
- AT control set
- Diameter: 30.5mm / 1.2" diameter
- Height: 4mm / 0.16 "/ 0.16"
- Weight: 2.5g
The smaller version of the map Adafruit FLORA ATTiny85-based11,94 € Add to cart
A coil of thin wire 2 strands to achieve electronic sewing e-textile.7,14 € Add to cart
An Arduino compatible card to achieve e-textiles made from ATMega32U4.17,94 € Add to cart
A Lithium Ion polymer battery15,00 € Add to cart
A WHEAT Bluetooth module for your microcontroller application.21,84 € Add to cart
A small card compatible Arduino M0 dedicated to IoT with its Bluetooth connectivity the35,94 € Add to cart
A Feather card with built-in Bluetooth wheat nRF52832 module.29,94 € Add to cart