Lithium Ion polymer - 3.7V 2(00mAh battery
Customers who bought this product also bought:
- Arduino Nano
- Buzzer Piezo - PS1240
- FeatherWing OLED - 128x32 OLED for Feather cards
- Lithium Ion polymer - 3.7V 500mAh battery
- JST PH 2-Pin Cable - Male Header 200mm
- Female stackable connectors 12 and 16 pins for Feather
- Mini speaker with cables - 8 ohm 0, 5W
- Sensor IR remote with cable (10cm - 80 cm) GP2Y0A21YK0F
- GP2Y0D810Z0F infrared obstacle detection sensor
Lithium Ion polymer batteries (also known as the "Lipo" or Lipoly"are thin, light and powerful. The output varies between 4, 2V to full charge and 3, 7V. This battery has a capacity of approximately 2500mAh for a total of 10Wh.
The battery has a female connector JST - PH 2 points and includes a protection circuit. This connector allows to avoid the short circuit, and has a keyed to avoid polarity inversion.
The built-in protection circuit allows to monitor the battery voltage so that she goes too high support (over-charging) or too low in use (over - use) which means that the battery will be cut if it drops to 3V. This circuit protects also short-circuits.
Attention: Even if this battery has a protection circuit, it is very important to use a LiIon Battery Charger / LiPoly voltage constant constant /courant to 1200mA or less. We suggest you use this model: Charger USB LiIon/LiPoly v1.2
As most of the Lipo, these batteries don't have built-in Thermistors, this is why we recommend that you load them to 1 c or less, or 100 MA to 500 Ma for this model.
Recommendations: Do not use a NiCad/NiMH/Pb charger with this battery. Do not drop, shock these batteries, avoid any shock. Also avoid put them in short circuit, do not bend them, open them or even the burn. All Lithiu Ion polymer batteries should be used by experts who know what they're doing with power supplies.
Size: 60mm x 36mm x 7mm / 2.4 "x 1.4" x 0.3 "
Connector JST - PH: Length 105mm / 4.1 "
Output: ±5% nominal 3.7V 2000mAh