ADS1015 CAN 12-bit 4-channel with PGA
Customers who bought this product also bought:
- Arduino Uno - DIP Rev3
- 5 X Double Terminal soldering 3.5 mm
- Thumb Joystick Module - Grove
- Grove Starter Kit V3
- Kit Camera Series - Grove
- Lot of power JST 2.5 mm male connectors and female
- Analog 2-axis Thumb Joystick with Select Button + Breakout Board
- 10 X resistors 0.25W 100 ohms
- GPIO Hammer Header Kit - Male + Female + Installation Jig
If you have a microcontroller that has no analog-to-digital converter (ADC or Currency), this basic ADS1015 module is perfect for you because it allows the acquisition of 4 analog channels with a prcission of 12-bit and up to 3300 samples per seconds through an I2C link. It is possible to configure the ADS1015 to acquire analog 4-way or 2-way differential.
The gift bonux of this converter, is that it has a built-in PGA, a programmable gain amplifier, which can multiply up to 16 a somewhat low entry to cover the maximum of the measurement range. At the feed level, it can be powered with 2V, 5V, and the logic of the signals also.
The circuit is welded on a map of breakout with a filter integrated on food to avoid disrupting the measures. The interface is carried out in I2C and the address can be changed in strappant the ADDR pine. Can be mounted to the max, 4 ADS1115 modules on a single I2C line.
Wide supply range: 2.0V at 5.5V
Low consumption: Continuous Mode: only 150µA Single-Shot Mode: Auto Shut-Down
Sampling rate: 8 echantilons per second to 3300 echantilons per second
Internal reference voltage
Interface I2C: 4 addresses selectable
4 entry into SINGLE-ENDED or two differential inputs
This module uses the addresses 7-bit I2C between 0 x 48-0x4B, selectable by jumper.
Example code for Raspberry PI: Adafruit_ADS1x15
Library and example for Arduino: Adafruit_ADS1X15