Adafruit RGB Matrix Featherwing Kit - For M0 and M4 Feathers
A FeatherWing specially designed to manage RGB IDC LED arrays with a Feather board based on M0 and M4.
Estimation de livraison entre le 08/04/2020 et le 09/04/2020
La Poste - So Colissimo
A partir de: 4,80 €
Customers who bought this product also bought:
- USB Mini B Female Plug to 5-pin Terminal Block
- Adafruit PCF8523 Real Time Clock Assembled Breakout Board
- Adafruit DotStar high density 8 x 8 - 64 LED RGB matrix
- Small Plastic Project Enclosure - Weatherproof with Clear Top
- FeatherWing Tripler Mini Kit - Prototyping Add-on For Feathers
- Flexible Protoboard - 20cm x 30cm
- VOC and eCO2 Air Quality Sensor - CCS811
- USB Micro B Male Plug to 5-pin Terminal Block
- USB Micro B Female Plug to 5-pin Terminal Block
Ahoy! It's time to create a stunning lighting project with our new FeatherWing RGB Matrix. Now you can quickly and easily create projects with your favorite 16 or 32 pixel raster maps. Using our RGB matrix library is easy and works perfectly with any of our Feather M0 or M4.
Note: This FeatherWing card has only been tested/designed to work with the SAMD21 M0 and SAMD51 M4 Feathers. It is not intended to be used with other feathers at this time.
This FeatherWing card can be assembled in two ways. You can either solder into a 2x8 IDC connector wrapped on top, then plug in the IDC cable supplied with your matrix. This makes it easy to stack on your pen. You can also solder into the 2x10 base at the bottom of the wing, then stack your feather on top. This way, you can connect it directly to the back of the matrix.
This FeatherWing will work perfectly with any of our 16x32, 32x32 or 64x32 RGB matrices, and it is certainly the easiest way to shine and fit.
Whatever your decision, you can plug a 5V DC power supply unit into the 2.1mm DC jack. This 5V is protected against polarity reversal and is then transmitted on the other side to a 5.08 mm terminal block. An on-board controller will provide a 3.3V power supply to your Feather, so you don't need a separate battery or USB port, making it a very compact device!
Each order comes with a FeatherWing printed circuit board with surface mount parts, 2x8 IDC connector, 2x10 socket, 2.1mm DC jack, 5.08mm terminal block, and male connector.
Product dimensions: 51.0 mm x 23.0 mm x 23.0 mm x 4.0 mm / 2.0 in x 0.9 in x 0.2 in
Product weight : 3.5g / 0.1oz
A HAT to easily manage a RGB LED with your Raspberry PI matrix.29,94 € Add to cart
An extension for Feather in order to illuminate your projects with 32 LED RGB Neopixels17,94 € Add to cart
A FeatherWing card with a 6 x 12 LED RGB Dotsatr RGB matrix for your Feather cards35,94 € Add to cart
A matrix of 64x32 LED RGB Flexible 5mm pitch with IDC connector158,33 € Add to cart
A FeatherWing to drive Neopixels in DMA.8,34 € Add to cart
An ideal shield to connect an RGB LED matrix to an Arduino board.7,14 € Add to cart