60 RGB LED Strip LED WS2812 - White - 1m
A white strip of 60 LED RGB of 1m based on WS2812.
Customers who bought this product also bought:
- LED Charlieplexed Matrix - 9 x 16 LEDs - yellow
- 5V opto-isolated relay module 4 channel 10A
- 60 RGB LED Strip LED WS2812 - Black - 1m
- Power supply module 7-12V to 3,3V 1A and 5V 1A
- ON-OFF button chrome with green LED Ring - 16mm
- 3 9V LR61 alkaline battery pack
- 1 X capacitors 1000µF
- Power supply 12V Arduino 2A 2.1 mm Jack
- 10 X resistors 0.25W 10kohms
This LED strip consists of 60 NeoPixel compatible RGB LEDs with integrated driver over a length of 1m. The width is 12,5mm with the protection and 10mm if you remove it. The FLEX PCB is black in color to make it less noticeable.
This LED strip is fabulous, but there are some important parameters to consider:
The more LEDs there are in series, the more it consumes, so you have to count 18W or about 3.5A under 5V even if the theory says that 5V 2A is enough. This max consumption is in the most defaroble case with all LEDs lit white, but generally the consumption is around 1.3A. To avoid any problems, the key is a good power supply, like 5V 10A.
The high density of LED with integrated driver, and having a serial protocol requires a very precise timing, it is thus necessary privileged micro-controller being able to make timings of 100ns. It can be used with Arduino UNO, MEGA, Raspberry PI or any other system with a clock frequency higher than 8MHz.
The large number of LEDs also requires a large memory size, so it is advisable to use an Arduino MEGA card to take healthy advantage of this RGB LED strip.
These LED strips are really fun, because you can control independently each of the 60 RGB LEDs, it is possible to adjust the component of each color of each LED (Red, Green and Blue) through an integrated PWM of 8 bits per channel, 24 bits per LED. The LEDs are controlled by an integrated shift register on each LED and chained from one to the other. It is therefore possible to cut the LED strip at the desired distance. The integrated controller also has internal PWM, which makes it possible to keep a value without necessarily sending it permanently.
Number: 60 LEDs per meter
Weight 1 meter (with silicone protection and coil): 39g
Protection: IP67 removable waterproof housing
5V maximum @ 60mA draw per segment of 0.65" segment (all full brightness LEDs)
Requirement 5VDC (not to exceed 6VDC) - no polarity protection
One RGB LED integrated per segment, individually adjustable
Connector: 3 pins JST SM
Packaged in 1m strips
Arduino Bookstore: https://github.com/adafruit/Adafruit_NeoPixel
The Arduino UNO card is the best seller from Arduino. Simple, effective and cheap.23,80 € Add to cart
The Arduino MEGA 2560, based on the ATmega2560 MCU, features a multitude of inputs/outputs.45,60 € Add to cart
Lot of 1 X capacitors 1000µF0,90 € Add to cart
An adapter with DC Jack Power female 2,1mm to screw terminal block2,40 € Add to cart