Customers who bought this product also bought:
- Jumper avec tirette - 2.54mm - Pack de 10
- LDR - Photoresistor
- 32 x 16 RGB LED matrix
- 10 X diode 1N4007
- Pack of 5 LED 5mm Diffused NeoPixel
- Lot of 12 cables with crocodile 381mm clips
- Lot de 18 cables avec pinces crocodiles 317mm
- GSM quad band antenna 2dBi SMA
- USB male/female lengthening with load/data switch
More info
Description
Arduino MKR FOX 1200 has been designed to offer a practical and cost effective solution for makers seeking to add SigFox connectivity to their projects with minimal previous experience in networking. It is based on the Atmel SAMD21 and a ATA8520 SigFox module.
The design includes the ability to power the board using two 1.5V AA or AAA batteries or external 5V. Switching from one source to the other is done automatically. A good 32 bit computational power similar to the Zero board, the usual rich set of I/O interfaces, low power SigFox communication and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor. The USB port can be used to supply power (5V) to the board. The Arduino MKR FOX 1200 is able to run with or without the batteries connected and has limited power consumption.
Warning: Unlike most Arduino & Genuino boards, the MKRFOX1200 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.
You can find here your board warranty informations.
Check your area coverage on the SigFox website
Getting Started
In the Getting Started section, you can find all the information you need to configure your board, use the Arduino Software (IDE), and start to tinker with coding and electronics.
Need Help?
- On the Software on the Arduino Forum
- On Projects on the Arduino Forum
- On the Product itself through our Customer Support
Data sheet
Micro-contrôleur | SAMD21 Cortex-M0+ 32bit low power ARM MCU |
SRAM | 32 KB |
Flash | 256 KB |
EEPROM | no |
Entrées/Sorties numériques | 8 |
Tension logique (GPIO) | 3,3V |
PWM | 12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19) |
Entrées analogiques | 7 (ADC 8/10/12 bit) |
Sortie analogique DAC | 1 (DAC 10 bit) |
Alimentation nominale | 5V |
Connectique pour chargement | micro USB |
Accessories
- 5,00 € Add to cart