Battery Lithium Ion polymer - 3.7V 100mAh
Customers who bought this product also bought:
- Block battery with JST connector and ON-OFF inter 3xAAA
- Lithium Ion polymer - 3.7V 1200mAh battery
- Adalogger FeatherWing - RTC + SD add-on for Feather card
- Adafruit Feather M0 Adalogger
- Buzzer Piezo - PS1240
- Adafruit Micro-Lipo Charger for LiPo/LiIon Batt w/MicroUSB Jack - v1
- Kit of 40 wires Male-Male gross customizable 150 mm Premium dupont
- FeatherWing engine driver - add-on for Feather card
- Adafruit GEMMA M0 - Miniature wearable electronic platform
Lithium Ion polymer batteries (also known as the "Lipo" or Lipoly"are thin, light and powerful. The output varies between 4, 2V to full charge and 3, 7V. This battery has a capacity of approximately 150mAh for a total of 0, 6Wh.
The battery has a female connector JST - PH 2 points and includes a protection circuit. This connector allows to avoid the short circuit, and has a keyed to avoid polarity inversion.
The built-in protection circuit allows to monitor the battery voltage so that she goes too high support (over-charging) or too low in use (over - use) which means that the battery will be cut if it drops to 3V. This circuit protects also short-circuits.
Attention: Even if this battery has a protection circuit, it is very important to use a LiIon Battery Charger / LiPoly voltage constant constant /courant to 100mA or less. We suggest you use this model: Adafruit Micro Lipo - charger USB LiIon/LiPoly.
As most of the Lipo, these batteries don't have built-in Thermistors, this is why we recommend that you load them to 1 c or less, or 100mA for this model.
Recommendations: Do not use a NiCad/NiMH/Pb charger with this battery. Do not drop, shock these batteries, avoid any shock. Also avoid put them in short circuit, do not bend them, open them or even the burn. All Lithiu Ion polymer batteries should be used by experts who know what they're doing with power supplies.
Weight: 4.65 g
Size: 19.75 mm x 26.02 mm x 3.8 mm / 0.77 "x 1.02" x 0.14 "
Connector JST - PH: 127.5 mm / 5 "
Exit: to roll 3.7V 150mAh
The smaller version of the map Adafruit FLORA ATTiny85-based11,94 € Add to cart
A minimalist USB charger for regearger easily your Lithium Ion batteries.7,20 € Add to cart
A USB loader to easily recharge your Lithium Ion batteries.15,00 € Add to cart
A back-back to simply add a battery on the Trinket.5,94 € Add to cart