Terminal Block Breakout FeatherWing Kit for cards Feather
A map of prototypega dedicated to the Feather family cards.
Estimation de livraison entre le 23/01/2020 et le 24/01/2020
La Poste - So Colissimo
A partir de: 4,80 €
Customers who bought this product also bought:
- Module Camera 8MP infrared for Raspberry PI V2
- NeoPixel FeatherWing - 4 x 8 RGB LEDS for cards Feather
- 3 in 1 Camera Lens Set
- FeatherWing engine driver - add-on for Feather card
- Adafruit I2S MEMS Microphone Breakout - SPH0645LM4H
- 20 Male - female 150mm Premium dupont wires Kit
- Balusters M2.5 16mm for Hat Raspberry - set of 2
- Adafruit PCF8523 Real Time Clock Assembled Breakout Board
- Analog 2-axis Thumb Joystick with Select Button + Breakout Board
The Terminal Block Breakout FeatherWing kit will allow you to easily prototype with any card Feather. A prototyping area is located under the Feather card with pellets split for the mass, the + 3, 3V for the SDA/SCL, pines of the Feather card connections have all been routed to Terminal screw and the card has 4 holes.
This kit is compatible all Feather card and the screw terminals are ideal for temporary facilities. The power supply GND and 3, 3V have even been dubbed on the terminals.
Is a space to weld a switch to activate the Enable pin, beware the Feather Fona map uses the tensions Vbat and 3, 3V, therefore it is not possible to turn off this card.
The kit is sold not welded with the circuit board, terminal blocks, connectors and the switch.
A small card compatible Arduino dedicated to storage on microSD card.23,94 € Add to cart
A small card compatible Arduino dedicated to IoT with its Wifi connectivity.20,34 € Add to cart
A small card compatible Arduino dedicated to IoT with its Bluetooth connectivity THE35,94 € Add to cart
A small card compatible Arduino dedicated to IoT with its GPRS connectivity53,94 € Add to cart