SN754410 - Compatible L293D
SN754410 - Compatible L293D
CI-SN754410
The SN754410 allows to control easily one engine with a Arduino.
Customers who bought this product also bought:
- Thermistor 10K - 3950 NTC - accuracy 1% Epoxy
- Arduino Uno - SMD standard R3
- CD4543BE: 7-compatible segment MC14543 BCD DECODER
- 40 Male - female 150mm Premium dupont wires Kit
- 2.1mm DC Power Jack with Slide Switch
- 16mm illuminated ON-OFF button - Green
- 90cm 3 ft Ethernet cable
- Connector Strip 6 points
- Pack of 200 Leds - 3mm and 5mm - Red Green Green Blue Yellow Yellow White
More info
The integrated circuit is a SN754410 Quad half H-bridge to control easily a motor Stepper with two coils.
It allows to control a current of 1 has under a voltage of 4.5V to 36V to power the engine coils step-by-step motors continuous relays, coils.
The inputs are compatible in TTL and CMOS low level level.
Example usage to control 2 Motors continuous:
| Pine | Name | Function | Notes |
| 1 | 1.2 IN | Activation engine 1 | By putting this pin to 0V (LOW or GND), this will cut the power to the motor and putting it to the 5V (HIGH), this will activate the motor power supply. |
| 2 | 1 A | Engine 1 Forward | A (HIGH) 5V on this pin will allow the engine to run in one direction. The speed can be controlled using a PWM. |
| 3 | 1Y | Motor 1 Power | This pin must be connected to one of the pins on the motor continuous. |
| 4 | Mass | Mass | This pin must be connected to ground. |
| 5 | Mass | Mass | This pin must be connected to ground. |
| 6 | 2Y | Motor 1 Power | This pin must be connected to one of the pins on the motor continuous. |
| 7 | 2A | Engine 1 Reverse | A (HIGH) 5V on this pin will allow the engine to run in reverse direction.The speed can be controlled using a PWM. |
| 8 | VCC2 | Power Source engine | This pin allows you to power your motor (max 36V) |
| 9 | 3.4 IN | Engine 2 Enable | By putting this pin to 0V (LOW or GND), this will cut the power to the motor and putting it to the 5V (HIGH), this will activate the motor power supply. |
| 10 | 3A | Motor Forward 2 | A (HIGH) 5V on this pin will allow the engine to run in one direction. The speed can be controlled using a PWM. |
| 11 | 3Y | Motor 2 Power | This pin must be connected to one of the pins on the motor continuous. |
| 12 | Mass | Mass | This pin must be connected to ground. |
| 13 | Mass | Mass | This pin must be connected to ground. |
| 14 | 4Y | Motor 2 Power | This pin must be connected to one of the pins on the motor continuous. |
| 15 | 4A | Engine 2 Reverse | A (HIGH) 5V on this pin will allow the engine to run in reverse direction. The speed can be controlled using a PWM. |
| 16 | VCC1 | Logic Power | Circuit power (+ 5V) |
Accessories
Arduino Uno - DIP Rev3
The Arduino UNO card is the best seller from Arduino. Simple, effective and cheap.
23,80 € Add to cart
Arduino MEGA 2560 R3
The Arduino MEGA 2560, based on the ATmega2560 MCU, features a multitude of inputs/outputs.
45,60 € Add to cart