Customers who bought this product also bought:
- Small motor not not have 5V with reducer
- MCP9808 temperature sensor I2C precision
- Mini Breadboard - Tests 170 contacts blue Platinum
- LED Arcade Button - 30mm Clear Blue
- Infrared remote control mini
- Electret microphone with amp MAX4466
- LDR - Photoresistor
- LED Arcade Button - 30mm Clear Red
- VS1053 Codec + MicroSD Breakout - MP3, WAV, MIDI, OGG Play + Record - v4
More info
With the HUZZAH32 Breakout Adafruit, your next ESP32 project will be in a pure state. This card is basically the'big sister' of our HUZZAH 8266, but instead of an ESP8266 it has the'32'! We have reduced our popular Feather ESP32 by removing the battery charger and USB-serial converter. You only have one controller, protective diodes, two buttons and one LED. For some projects, where the price and size are higher, you can program this card via the FTDI cable if necessary, and then let it run.
Note that this card is not supplied with a USB-to-serial converter chip and an automatic reset circuit. Instead, you will need to connect a CP2104 Friend or FTDI cable. Then, before downloading the code, put it in bootloader mode by holding down the GPIO #0 button and clicking on the Reset button, then releasing the #0 button.
This module contains a dual-core ESP32 chip, 4 MB of SPI Flash, a tuned antenna that you need to take advantage of this powerful new processor. The ESP32 supports WiFi and Bluetooth Classic/LE. This means it is perfect for just about any wireless or Internet-connected project.
The ESP32 is a perfect update of the ESP8266 that has been so popular. In comparison, the ESP32 has many more GPIOs, many more analog inputs, two analog outputs, several additional devices (such as a spare UART), two cores so you don't have to give up to the WiFi manager, much faster processor, etc.
Delivered fully assembled and tested, pre-programmed with the ESP32 SPI WiFi coprocessor firmware that you can use in CircuitPython to use in a WiFi coprocessor on SPI + 2 pins. We also add a connector so you can solder it and connect it to a solderless breadboard.
Here are Espressif's specifications for the ESP32:
Tensilica LX6 240 MHz dual-core microcontroller with 600 DMIPS
Integrated 520 KB SRAM
HT40 Wi-Fi transceiver 802.11b/g/n HT40, baseband, battery and LWIP integrated
Integrated dual-mode Bluetooth (classic and BLE)
4 MB flash included in the WROOM32 module
On-board PCB antenna
Analog amplifier with very low noise
Hall sensor
10x capacitive touch interface
32 kHz quartz oscillator
3 x UARTs (only two are configured by default in Feather Arduino IDE support, one UART is used for bootloading/debug)
3 x SPI (only one is configured by default in Feather Arduino IDE support)
2 x I2C (only one is configured by default in Feather Arduino IDE support)
12 x ADC input channels
2 x I2S Audio
2 x DAC
PWM input/output/ timer available on each GPIO pin
OpenOCD debugging interface with 32 kB of TRAX buffer memory
SDIO master/slave 50 MHz
Support for SD card interface
Technical details
Product dimensions : 44.0 mm x 25.5 mm x 4.8 mm / 1.7" x 1.0" x 0.2" x 0.2
Product weight: 5.8g / 0.2oz
Accessories
- 23,94 € Add to cart