Arduino MKR FOX 1200 w/o Antenna
Customers who bought this product also bought:
- 10 x BC547 Transistors - NPN
- Wheel for servo motor
- Ceramic resonator 8 MHz oscillator
- No engine has no 12V NEMA17 200 step/rev 350mA
- Pack of 10 connectors Grove Universal 4 pins 90 °
- Adafruit SGP30 Air Quality Sensor Breakout - VOC and eCO2
- Mini spy Camera with trigger for photo and video
- Mini fan 5V for Raspberry PI and other computers
- 10 X 10nF capacitor
Arduino MKR FOX 1200 has been designed to offer a practical and cost effective solution for makers seeking to add SigFox connectivity to their projects with minimal previous experience in networking. It is based on the Atmel SAMD21 and a ATA8520 SigFox module.
The design includes the ability to power the board using two 1.5V AA or AAA batteries or external 5V. Switching from one source to the other is done automatically. A good 32 bit computational power similar to the Zero board, the usual rich set of I/O interfaces, low power SigFox communication and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor. The USB port can be used to supply power (5V) to the board. The Arduino MKR FOX 1200 is able to run with or without the batteries connected and has limited power consumption.
Warning: Unlike most Arduino & Genuino boards, the MKRFOX1200 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.
You can find here your board warranty informations.
Check your area coverage on the SigFox website
|Micro-contrôleur||SAMD21 Cortex-M0+ 32bit low power ARM MCU|
|Tension logique (GPIO)||3,3V|
|PWM||12 (0, 1, 2, 3, 4, 5, 6, 7, 8, 10, A3 - or 18 -, A4 -or 19)|
|Entrées analogiques||7 (ADC 8/10/12 bit)|
|Sortie analogique DAC||1 (DAC 10 bit)|
|Connectique pour chargement||micro USB|