Adapter USB to Xbee
Adapter USB to Xbee
MR002-004.1
An adapter to easily connect a module Xbee to USB port.
Customers who bought this product also bought:
- Transmitter and receiver 433 MHz RF modules
- 5 X capacitor 10µF
- Wireless SD Shield
- Arduino Micro
- Block battery 4xAA with ON-OFF inter
- Keyboard Silicone elastomer 4 x 4 - for 3mm LED
- Arduino Uno - DIP Rev3
- DHT11 - Sensor of temperature and humidity digital
- Female stackable connectors 12 and 16 pins for Feather
More info
Description
This adapter USB to Xbee ets ideal to connect a PC to a module XBee, or to interact with a micro-controller through the network Xbee wireless. The connection is through a uSB port and the module is recognized as a virtual serial port VirtualCOM Port (VCP), which allows to establish dialogue with the Xbee module.
It is compatible with all of the Xbee modules, including the series 1, 2.5, Standard and Pro. The connection to the PC allows to configure the Xbee modules with the software Digi's X - CTU.
The has 4 cards LED to visuliser Power, RSSI, TX and RX signals.
This little card is barely 39 x 25 mm including the mini-USB connector and it only weighs 5g. the map has a connector to the steps of 2.54 mm to the adpater easily on a breadboard.
Sold with two connectors 10 points with the steps of 2mm and two connector 10 points at 2.54 mm welded no no.
Documentation
Drivers: FTDI driver