Module clock RTC - DS1307
Customers who bought this product also bought:
- 20 female - female 150mm Premium dupont wires Kit
- Steerable 2.4 GHz Dipole antenna with RP - SMA - 2dBi
- MicroSD card breakout board +
- Push-button (P) - Grove
- Adafruit Micro Lipo - charger USB LiIon/LiPoly
- Stepper Motor 17HS4401 12V NEMA17 200 steps/rev 1.7A
- Cable JST Femelle 2 pins 100mm
- MPL115A2 barometric-temperature pressure sensor
- Mini Breadboard - Tests 170 contacts blue Platinum
This product is a carrier for the integrated circuit board Maxim DS1307?.
The DS1307 is a real-time clock (RTC) series of low power, we find information binary ?-coded decimal (BCD) clock and calendar as well as 56 bytes of NV SRAM relief.
Address and data are transferred serially by a bidirectional I2C bus.
The function clock / calendar provides seconds information, minutes, hours, day, date, month, and year. The end of the month date is automatically adjusted for months with fewer than 31 days, including corrections for leap year. The clock is in 24-hour or 12 hours with indicator AM / PM.
The DS1307 is equipped with a sensor that detects power failures and automatically switches to the backup power.
An open-drain output signal is intended to achieve a programmable clock at 1 Hz, 4.096Khz, 8.192Khz, 32, 768kHz; This function is very useful to synchronize your application with "to the second of reference" or one of its multiples. This output can also be attached to the logical level up or down through internal registry, allowing you to use this for debugging routines or test signal.
Three places are available for soldering the connector, you can also choose to weld a Connector? right or a90 °: it gives you the possibility of posionner at best this RTC editing in your specific applications.
Its small size, low power and ease of use make this RTC module ideal for the implementation of time for your rigs DIY systems.
For more details on the serial communication and internal registers, refer to the plug Maxim DS1307 on the tab download.
The circuit includes: the PCB with the DS1307 circuit? welded and two connectors 5 points (a right and one elbow 90 °) sold without battery.
- Power supply: 4 .5V to 5, 5V
- Consumption: 1.5 my type. (0.5 my battery backup mode)
- Interface: I2C
- Size: 32 x 23 x 11 mm
- Weight: 5g
CR2032 3V Lithium button cell battery.1,80 € Add to cart
Cable 30 cm 5-point female - male
Ideal cable to connect a sensor Microbot to an Arduino board.3,74 € Add to cart