Description

This kit of components is ideal to follow the MOOC of France digital University - program an object with Arduino, it also was designed in partnership with trainers from the course to match best to it.

You just have to add only the Arduino UNO card to have all the elements necessary pursuit of the basic course.

With this essential kiti, you can complete your training with the following optional equipment:

Key-pad with contact × 1
Thermistor × 1
Transistor MOSFET-N "Logic level" × 1 
Transistor P-MOSFET "Logic level" × 1 
Module controllable 5V relay to switch up to 230V × 1
Module extension (shield or breakout board) Ethernet (of your choice):
     (based on Breadboard W5100 chip) × 1 (more expensive but easier to use with the Arduino UNO)
     (based on chip ENC28J60) x 1 (cheaper but memory)
Mini Servo Motor × 1 (choose the largest possible opening angle)
Plastic case to contain components and the Arduino × 1 (really optional :))

Features

This kit includes the following:

• 1 X Breadboard 830 points
• 1 X Kit over 40 wires (depending on availability of 40 to 70 wires flexible or rigid)
• 1 X USB cable type A - B
• 2 X LED 5 mm RED
• 2 X LED 5 mm GREEN
• 2 X LED 5 mm YELLOW
• 1 X LED RGB common Anode (or common Cathode, depending on availability)
• 10 X RESISTORS 150 Ω
• 10 X RESISTANCE 220Ω
• 11 y RESISTANCE 1kΩ
• 10 X RESISTORS 4.7 kΩ
• 10 X RESISTANCE 10 kΩ
• 1 X temperature sensor LM35DZ or TMP36 (according to availability)
• 2 X CAPACITOR 10nF
• 2 X 100nF CAPACITOR
• 2 X CAPACITOR 10ΜF
• 2 X CAPACITOR 47ΜF
• 2 X 470ΜF CAPACITOR
• 5 X PUSH BUTTONS
• 2 X DIODE 1N4148
• 2 X TRANSISTOR NPN BC547
• 2 X BC557 PNP TRANSISTORS
• 1 X PHOTORESITANCE
• 1 X 10KΩ POTENTIOMETER
• 1 X CONNECTOR STRIP 40 POINTS
• 1 X PIEZO
• 1 X 2 X 16 LCD DISPLAY

Documentation associate

Tutorials: Digital manufacturing