Pimoroni OnOff SHIM! for Raspberry Pi
A simple and intelligent switch to control the ignition and switch off your PI.
Estimation de livraison entre le 29/01/2020 et le 30/01/2020
La Poste - So Colissimo
A partir de: 4,80 €
Customers who bought this product also bought:
- Connector Strip scored 40 points
- OLED Display White 0.96" 128x64 Graphic
- Illuminated push button 16mm - Orange
- DC Power 2.1 mm male to terminal block adapter
- Illuminated push button 16mm - White
- Kit of 50 female - female 100mm wires
- USB cable type A - B
- Reference map of GPIO for Raspberry model B +.
- 610mm Flex cable for camera raspberry PI
Add a tiny yet convenient power switch to your Pi with OnOff SHIM!
Our SHIMs (Shove Hardware in the Middle) are a new range of boards designed to be small, affordable, and handy. They're just 1mm thick (the bare board, not including mounted components) and designed to be soldered straight onto the GPIO pins of your Pi, if you wish, so that you can use them with HATs and pHATs on top.
Update: In addition to our regular individual slimline postage friendly packaging OnOff SHIM is now available retail packaged with each OnOff SHIM in its own colourful blister pack, ideal for retail display!
Just plug your micro-USB power supply into the micro-B connector on OnOff SHIM, and then press the button once to switch on power and boot up your Pi. After installing our software (details below), you can press the button again to initiate a clean shutdown and completely cut the power to your Pi.
super-small SHIM-format board
1mm thick PCB
can be used with HATs and pHATs
corner-mounted push button for on/off
micro-B connector for power supply
red status LED
optional breakout pins to connect an external momentary button
2x6 female header included
software daemon to shutdown cleanly
We've put together a one-line-installer to install the clean shutdown daemon. It watches the state of BCM pin 17 and, when pulled low (pressed), it initiates a clean shutdown. Last thing, just before your Pi shuts down, BCM pin 4 is pulled low to completely cut power to your Pi.
To install the software, open a terminal and type curl https://get.pimoroni.com/onoffshim | bash to run the one-line-installer.
This module is a simple push button to control a switch mode supply.7,14 € Add to cart
Ideal switch to function ON / OFF or change of polarity.1,14 € Add to cart
A map of breakout with a connector JST - PH 2 pines with ON-OFF switch for the power supply.2,10 € Add to cart
A breakout with a medium crate battery CR1220 12 mm with ON-OFF switch3,30 € Add to cart
- 41,28 € Add to cart