Kelvin pliers
ADA 3313
data-lang="en">
Ideal Kelvin clamp for small component measurements SMD
Customers who bought this product also bought:
- Cable JST Femelle 2 pins 100mm
- FeatherWing power relay - add-on for Feather card
- 10 X resistors 0.25W 100 ohms
- Braid a unsolder 1.5 m x 2 m without cleaning
- Prototyping Hole Plates 8cm x 12cm
- Touch button with ball metal 6mm - Pack of 10
- Resistance RESK Kit
- Sensor of UV index, infrared, and visible light SI1145
- Infrared receiver LED - Grove
More info
Description
Kelvin clips are used whenever you need to measure directly at the contact points of a circuit or component. Even if they are grippers, each side of the gripper is electrically isolated. You can therefore use it to enter a part and take measurements. These can also be used in a circuit if necessary.
The clip is bare and comes with two jaw contacts that are screwed on either side of the plastic clip. No wires are included, but you can easily solder them to the jaws of the pliers.
Features
- Dimensions: 51.5mm x 25.0mm x 12.4mm / 2.0" x 1.0 "x 0.5" / 2.0 "x 1.0" x 0.5
- Weight: 5.5g / 0.2oz