Mini relay not maintained FeatherWing - add-on for Feather card
Customers who bought this product also bought:
- Adalogger FeatherWing - RTC + SD add-on for Feather card
- RTC module with super capacitor
- Female stackable connectors 12 and 16 pins for Feather
- Adafruit Feather M0 RFM95 LoRa Radio - 900 MHz
- FeatherWing power relay - add-on for Feather card
- Resistance RESK Kit
- FeatherWing Proto for Feather card
- Lithium Ion polymer - 3.7V 2000mAh battery
- Force round sensor - Sensitive Resistance (FSR) Interlink 402
A Feather card without ambition, it's a Feather without FeatherWing card! This card featherWing realis not maintained will allow you to control the power with your Feather card like a lamp, a fan, or a solenoid.
This version of FeatherWing is with Relay not maintained. This featherWing need a single pin SET, base pin of the NC relay is connected to the COM PIN and the pin no. is disconnected.
When SET is active, the relay clicks and the COM pin is connected to the pin no., the NC PIN is then disconnected.
When the relay is active, a LED is lit and the relay consumes about 50mA to be maintained. If the power is off, the relay will not return to the base state "open".
If you do not want to lose 50mA to save a battery, need you the version with maintained relay. It will require 2 pine, but it will remain in its last State in case of power failure.
These two FeatherWing use the same family of relay, you can drive 2A 30VAC or 40VDC or less. At 110VDC, no longer 0, 3A, to 120VAC up to 0.5 A and under 250VAC, you can switch up to 0, 6a. Remember to check your balance of consumption and refer to the documentation of the relay before plugging anything.
Each card FeatherWing is sold tested and assembled without welded connectors.
Attention: If you use higher at 24 v voltages, be careful and make evidence of common sense. You know the rules of electric base security to avoid any accident.
- Dimensions: 50.8 mm x 22.9 mm x 11.4 mm / 2 "x 0.9" x 0.45 "
- Weight: 5.6 g
A small card compatible Arduino dedicated to IoT with its Wifi connectivity.20,34 € Add to cart
A small card compatible Arduino dedicated to IoT with its Bluetooth connectivity THE35,94 € Add to cart
A small card compatible Arduino dedicated to IoT with its GPRS connectivity53,94 € Add to cart
A batch of two connectors stacked females 12 and 16 pins for Feather.1,20 € Add to cart
A batch of two female connectors 12 and 16 pins for Feather.1,14 € Add to cart