Lithium Ion polymer - 3.7V 1200mAh battery
Customers who bought this product also bought:
- DC Power 2.1 mm female to terminal block adapter
- Thumb Joystick Module - Grove
- Spool of thread thin 3 Strand stainless - 18 m
- TFT FeatherWing - 2.4 "320 x 240 touchscreen for Feather card
- Solar Panel medium 6V 2W
- Cable RP - SMA to uFL - u.FL - IPX-IPEX-RF
- Peristaltique pump 12V for liquid with silicone tubes
- Button pousoir Power Switch Breakout - Adafruit
- Inertial 9 - DOF Accel/Mag/Gyro + Temp - LSM9DS1
Lithium Ion polymer batteries (also known as the "Lipo" or Lipoly"are thin, light and powerful. The output varies between 4, 2V to full charge and 3, 7V. This battery has a capacity of approximately 1200mAh for a total of 4, 5Wh.
The battery has a female connector JST - PH 2 points and includes a protection circuit. This connector allows to avoid the short circuit, and has a keyed to avoid polarity inversion.
The built-in protection circuit allows to monitor the battery voltage so that she goes too high support (over-charging) or too low in use (over - use) which means that the battery will be cut if it drops to 3V. This circuit protects also short-circuits.
Attention: Even if this battery has a protection circuit, it is very important to use a LiIon Battery Charger / LiPoly voltage constant constant /courant to 100mA or less. We suggest you use this model: Charger USB LiIon/LiPoly v1.2
As most of the Lipo, these batteries don't have a built-in thermistor, that is why we recommend that d silt load in 1/2 C or less, or 500mA for this model.
Recommendations: Do not use a NiCad/NiMH/Pb charger with this battery. Do not drop, shock these batteries, avoid any shock. Also avoid put them in short circuit, do not bend them, open them or even the burn. All Lithiu Ion polymer batteries should be used by experts who know what they're doing with power supplies.
Size: 34mm x 62mm x 5mm / 1.3 "x 2.4" x 0.2 "
Connector JST - PH: Length 105mm / 4.1 "
Exit: to roll 3.7V 1200mAh